I use a double par buckle (one on each side of the log). Remember that when you use the double-pull set up it will not only double the pulling power of your winch but, it will cut the pull speed in half. Par buckle behaves like a double line pull with the log acting like a snatch block. Connect the snatch block to an anchor point directly in front of the vehicle. In self-recovery, the cable is run through the snatch block then back to your vehicle. This anchor point takes some of the strain off your vehicle, which is important when you are recovering a heavier rig. The winch cable goes through the snatch block and back to an anchor point that’s next to your vehicle. If you are moving another vehicle,the stuck vehicle is attached to the snatch block. 5 (2) Quadratec D-Ring 2' Receiver Hitch Mount. These reduce the load on the winch by half as a pully or just simply change the angle of the pull. A double-line pull is created by using the snatch block to redirect the winch cable back to the winch. Snatch blocks are perfect for those who use their winch frequently during recovery or for pulling of heavy items. When dual pull action is needed-When you are recovering a rig that is significantly heavier than yours or if you’re not sure your winch will have the power to recover your vehicle, you can use a snatch block to create a double-line pull. If you pull at an angle, the cable is more likely to bunch up on one side of the winch drum. This is easiest when you are winching straight forward. Then use the tension from the two off-set anchor points to position the block directly in front of your vehicle.Ī winching essential for safety and effectiveness. One of the rules of winching is to make sure your cable spools up on the winch drum evenly. Attach the snatch block to the second anchor point with a choke chain. Then you need to identify a second anchor point that’s angled in the opposite direction as the first anchor point. This involves running the winch cable through the snatch block to an anchor point that is off at an angle.
When this isn’t possible, you can use a snatch block to set up an angled, single-line pull. When do you use it? In a recovery situation, ideally you would have an anchor point located directly in front of your vehicle, so that you don’t have to angle your winch cable. A snatch block will increase your winch’s pulling power significantly, and will give you more options in self-recovery situations. It’s a handy piece of equipment that can improve the function of your winch. Because the side plate opens, you don’t have to thread your winch cable through the opening, instead you open the side plate, fit the cable over the pulley, and then close the side plate. What is a snatch block? A snatch block is a pulley block with a side plate that swings open.
0 kommentar(er)
